- A+
Introduction
Epson have been producing high-quality printers for many years, and their Epson 1390 model is no exception. However, the ink cartridges in this printer need to be replaced from time to time, and over time, the waste ink tank can become full. When this happens, you need to remove the waste ink tank so that it can be emptied and cleaned. In this article, we will discuss how to disassemble the Epson 1390 waste ink tank.
Step-by-step Guide to Disassemble the Epson 1390 Waste Ink Tank
Before starting the disassembly process, make sure you have the necessary tools to complete the task. The following tools will be required:
Tweezers
Screwdriver
Electric drill
Scissors
Now that you have all the necessary tools, you can begin the disassembly process of the Epson 1390 waste ink tank.
Step 1: Removing the Printer Cover
The first step is to remove the printer cover so that you can access the waste ink tank. To do this, turn off the printer and unplug it from the wall outlet. Next, remove the screws that hold the printer cover in place and gently lift the cover off the printer.
Step 2: Locating the Waste Ink Tank
The Epson 1390 waste ink tank is located on the right-hand side of the printer. It is a small, rectangular box that is attached to the printer by two screws.
Step 3: Removing the Waste Ink Tank
Using the electric drill, remove the screws that are holding the waste ink tank in place. Next, gently pull the waste ink tank out of the printer. Be careful not to damage any of the wires or cables that may be attached to the tank.
Step 4: Disassembling the Waste Ink Tank
Now that you have removed the waste ink tank from the printer, you can begin to disassemble it. Start by removing the ink pad from the tank. You can use tweezers to gently pry the pad out of the tank. Next, use scissors to cut the pad into small pieces. This will make it easier to dispose of the pad.
After you have removed the ink pad, you can start cleaning the inside of the waste ink tank. Use a cloth and some warm soapy water to clean the tank thoroughly. Make sure you get rid of all the ink residue.
Step 5: Reassembling the Waste Ink Tank
Once you have cleaned the waste ink tank, you can begin to reassemble it. Put the ink pad back into the tank and screw the tank back into place on the printer. Finally, put the printer cover back on and screw it into place.
Conclusion
The Epson 1390 waste ink tank will need to be emptied and cleaned from time to time. By following the steps outlined in this article, you can disassemble the tank and clean it thoroughly. Remember to be careful when removing the tank and to avoid damaging any of the wires or cables attached to the tank.
