- A+
Brother 9020 Printer Reset: How to Clear the Count
If you have a Brother 9020 printer and you notice that the printed pages counter is reaching the end of its life, it's time to reset the counter and clear the count. This process will allow your printer to start printing pages again, without any error messages or warnings. Here are the steps to reset your Brother 9020 printer:
Step 1: Open the Printer Cover
The first step is to open the printer cover of your Brother 9020 printer. This can be done by lifting the cover on the top of the printer unit. Once you lift the cover, you will see the toner cartridge and the drum unit inside.
Step 2: Press the GO Button Three Times
Next, you need to press the GO button on your printer three times within two seconds. The GO button is located on the front of the printer unit, and pressing it three times will put the printer into reset mode.
Step 3: Check the Drum and Toner Units
Once the printer is in reset mode, you need to check the drum unit and the toner cartridge. Make sure both units are properly installed and locked into place. If either unit is not properly installed, the printer will not reset properly.
Step 4: Press the GO and + Buttons
After verifying that the drum and toner units are properly installed, you need to press the GO and + buttons at the same time. The GO button is on the front of the printer, and the + button is on the keypad located on the top of the printer. Hold both buttons down for a few seconds until the printer's LCD screen says "Reset."
Step 5: Close the Printer Cover
Finally, close the printer cover and wait for the printer to properly reset. The process should take no more than a few minutes, and once the printer has reset, it will print pages again without any issues.
Resetting your Brother 9020 printer is a simple process that should be done regularly to ensure that your printer is working efficiently without errors or warnings. Following these steps will allow you to clear the count and start printing pages again with ease.
