- A+
Brother 3170 A Solution to Clearing Printer Ink Waste Reservoirs
Brother 3170 is a highly efficient printer that excels in producing high-quality prints. However, with great efficiency comes great waste. The printer ink waste reservoirs, also known as ink absorbers, fill up with waste ink over time and need to be cleaned out for the printer to continue functioning optimally. In this article, we will discuss how to clear the printer ink waste reservoirs of Brother 3170.
What are Printer Ink Waste Reservoirs?
Printer ink waste reservoirs, also called ink absorbers, are used in inkjet printers to provide a place for the waste ink to go as the printer runs. The main job of an ink absorber is to soak up the excess ink that is expelled during the printing process. Over time, the ink absorbers fill up, and this causes the printer to malfunction. The printer may display error messages such as "ink waste reservoir almost full" or "ink absorber full".
Why Clear the Printer Ink Waste Reservoirs?
If the printer ink waste reservoirs are not cleared on time, the printer may stop working entirely. The waste ink reservoirs come with a limit, and when the limit is reached, the printer will go into an error state. Clearing the waste ink reservoirs is an essential part of printer maintenance, and it helps to keep the printer in good working condition and increases its lifespan.
How to Clear the Printer Ink Waste Reservoirs?
Clearing the printer ink waste reservoirs can be a bit tricky, and it is recommended to follow the manufacturer's instructions. Here are the steps to clear the ink absorbers of Brother 3170:
Turn off the printer and unplug it from the power source.
Locate the ink absorber cover by opening the printer's cover and looking for a rectangular piece of plastic with two screws on either side. Loosen the screws and remove the cover.
Remove the ink absorber pads and place them in a bowl of warm water and gently massage them to loosen the dried up ink. Leave them in the water for a few minutes.
Remove the ink absorber pads from the water and squeeze them out until no more ink comes out. Repeat this process until the pads are completely clean.
Let the pads dry completely before placing them back into the printer.
Replace the ink absorber cover and screw it back into place.
Turn on the printer and verify that the error message has cleared.
Conclusion
Clearing the printer ink waste reservoirs of Brother 3170 is an essential part of printer maintenance, and it helps to keep the printer in good working condition. By following the steps outlined in this article, you can clear the ink absorbers easily and quickly. Remember to use caution while handling the ink absorber pads and to follow the manufacturer's instructions to avoid damaging your printer.
